Before you fit our adapter, you must determine whether your bike is approved for trailer use. Check the operating instructions for your bike, ask the manufacturer or ask a bike dealer.

The towing bike must be approved for trailer operation. Riding the trailer with a towing bike that has not been approved by the manufacturer can lead to frame breakage or other material problems. This can result in accidents with life-threatening injuries.

If you are not sure how to install our adapter correctly, please contact a specialist workshop.

Our adapter must be fitted correctly. An incorrectly fitted adapter can come loose while riding and lead to accidents with life-threatening injuries.

You should definitely bear this in mind: 

• Our adapters are only approved for bicycles and pedelecs (max. 25 km/h), not for S-pedelecs or e-bikes from 25 km/h!

• We would like to point out to all dealers and end users that they themselves are responsible for the entire bicycle trailer system and its correct functioning in terms of product liability!

• It is your responsibility to determine the correct thread size of your rear hub on your bike. Do not attempt to fit our adapter with a different thread size to your rear hub. An incorrect thread size can damage your bike. If you are unsure of the correct thread size, please contact us by email or phone and we will be happy to help you. 

• cannot be used with bikes made of carbon or with carbon dropouts and carbon rear triangle!

• Regularly check the correct torque setting and that all components are free of play before using your bike in trailer mode!

• If you do not have a calibrated torque wrench for fitting our adapter, contact a specialist workshop.

FOR ASSEMBLY

The first step is to remove both cylinder screws M7 x 1.00 x 30mm - 36mm - 42mm(green) including Nord Lock wedge lock washers.

Now screw the two threaded bolts M7 x 1.00 x 30mm - 36mm - 42mm supplied with the small NordLock wedge lock washers øDi 7.2mm into the Rohloff A12 hub on the left and right. 

To do this, you will need a torque wrench with a 5 mm hexagon socket attachment. The specified tightening torque is 16-18 Nm.

Then slide the black 3 mm spacers on the left and right, followed by the large NordLock circular lock washers (øDi 10.7 mm), over the threaded bolts. (M10 x 1.00)

Now you can screw your Burley adapters M10 x 1.00 onto the threaded bolts. The tightening torque of the adapters should NOT be higher than that of the threaded bolts. We recommend a maximum of 16 Nm.